Use CMPS only for registered members

[BlackRanger3d]

Sorry for simple question.

Can I set CMPS, so that it can only be seen by registered users, ie guest don't get to see it?



I realy did search, and I did not see anything.

BR3d

[KW802]

BlackRanger3d,

In your CMPS page properties you should see a section for permissions as to which usergroups have permissions to view the page.

[BlackRanger3d]

Thanks man. I thought there would be, I just did not want to start editing files and such and then find out it can not be done.

Cheers.

I will have to install this puppy.

[KW802]

Thanks man. I thought there would be, I just did not want to start editing files and such and then find out it can not be done.

Cheers.

I will have to install this puppy.Sorry, I thought you already had it installed. :p

Yes, after you install it and go into the CMPS Control Panel you'll find that permissions are set on two different levels. The first level is at the page level so you go into the page properties you can turn off & on the viewing permissions of the entire page by usergroup. The second level is at the individual module level and the same principle applies, you can turn off & on viewing permissions of the module by usergroup. That allows you to do stuff like 'Unregistered users can view the page but they can view module X' and vice versa 'Everybody can view this page but only unregistered users will be shown module Y that prompts them to register' and so on.

Let us know if any problems. :)