PDA

View Full Version : Moderation


dilbert05
11-08-2009, 05:41 PM
I have multiple instances.
I just installed a new instance this weekend, it was a new download too.

I have it set up as a file sharing system where the documents need to be approved first.
I currently have 5 documents pending moderation.
There doesn't seem to be a way to review approve them individually, what happens if I want to reject only one?
Also I can't see the attachment when I try to approve it, that makes it a bit tough to "moderate".

The bigger issue though is when I click Submit to Validate all, it goes back to the same page and leaves them pending validation. I can't get them to validate.

Did I set it up incorrectly?

Thanks

Brian
11-09-2009, 01:53 PM
It sounds like you're clicking the 'Ignore All' radio button at the top of the screen before clicking the Submit button if there are no changes afterward.
If you only want to reject one entry, just change the radio button below that entry to 'Delete' or 'Ignore'. That will delete/ignore that entry while processing the rest.

Our Sponsors
 

dilbert05
11-09-2009, 02:48 PM
Thanks for the reply Brian.
When I load the moderation page, the Validate All is already selected.
When I click submit, none are validated.
Also, each individual post does not have a 'Delete' or 'Ignore' radio, just the overall group.
I suspect something went awry with the install?
5578

Brian
11-09-2009, 03:46 PM
Ahhh, there should be a row of buttons at the bottom of each entry there so you can approve/delete/ignore each one individually. Double check your 'adv_dyna_moderate_actionrows' template to make sure it hasn't been modified, and if it has, try reverting it. Note that the template will start with whatever you used for the instance prefix with that instance instead of 'adv_dyna' since this is a secondary instance.

Our Sponsors
 

dilbert05
11-09-2009, 04:12 PM
Very strange.
It wasn't edited, so there's nothing to revert.
I tried re-installing the templates, and it's the same.

Brian
11-09-2009, 04:45 PM
Weird... Would you mind submitting a support ticket via the Members' Area here then so I can take a look and see what the problem is?

dilbert05
11-09-2009, 06:32 PM
Thanks, submitted.